Ironwood 1911 grip set....calling Murphy-

by Gunner ⌂ @, St Louis, Sunday, September 16, 2018, 18:19 (86 days ago)

Finally tried making a set of 1911 grip panels.....couldn't get motivated to grind a heat treated blade so I grabbed a set of Desert Ironwood scales and started cutting, shaping and sanding...

[image]


Not too bad for my first attempt, lost track of keeping the tops some what even, too focused on fitting the left panel under the plunger tube so they are a little different shaped. Sanded to 600 grit and buffed out, I used my 5" Baer for test fitting and cut the panels a little wider than normal and flat bottomed them as well, personally I prefer the Baer style grip panels, so that is kinda what I made them to look like.


Murphy you have been after me to make a set so here you go, $60 shipped as is, if you want them, if not no biggie, they will go to the first "I'll take them" posted here.

Gunner

--
www.gunnerblades.com
https://www.instagram.com/gunnerblades/
41 Mags rule, Baers rock!


Complete thread:

 RSS Feed of thread

powered by my little forum