Stripped screw issue

by Fivegunner @, LOWELL Mi., Wednesday, November 22, 2017, 09:57 (25 days ago) @ stonewalrus

How about trying the next size Torx bit, If it is close but won`t fit a few tap`s of a small hammer might drive the torx bit in to the head of the Trox head screw enough to get a good bite on the screw, just hope there's no Loctite on it. If so you need to heat it up to about 300 deg. My 2 cents.:-D


Complete thread:

 RSS Feed of thread

powered by my little forum